Pegler Yorkshire Logo

Leger thermostatic bath shower mixer, without shower kit


Leger thermostatic bath shower mixer, without shower kit
Pattern No.L555 CP
Pack 1 Qty1
Pack 2 Qty4
Price (£) each ex VATPOA


Leger thermostatic bath shower mixer, without shower kitdimensions
Pattern No.L555 CP
Individual Weight (kg)4.81
Pack 1 Weight (kg)4.81
Pack 2 Weight (kg)20.09
Pattern No.L555 CP
Pegler Yorkshire reserve the right to change specifications

Leger thermostatic bath shower mixer, without shower kit



5 Year Guarantee

Luxury Taps and Mixers

Pegler Customcare 5 Year Guarantee - Terms and Conditions

Product are subject to a 5 year guarantee that is between Pegler and the final purchaser of the product.

The guarantee is subject to proof of purchase being supplied.

This guarantee does not affect any statutory rights the consumer may have in law.

The guarantee covers manufacturing or material defects and does not cover parts subject to normal wear and tear. 

Finishes other than chrome are covered for a period of 3 years only and the guarantee on the finish is subject to the cleaning instructions being followed.

The guarantee is not applicable where the product is fitted contrary to the conditions in the fitting instructions.

Abusive behaviour and accidental damage to the product are not covered by this guarantee.

The extent of this liability is limited to the cost of the replacement of the defective item and not to fitting or consequential damages.

DescriptionMinimum Operating
Pressure (bar)
Maximum Cold Working
Pressure (bar)
Maximum Hot
Working Pressure (bar)
Thermostatic bath shower mixer0.1 bar6.0 bar at temperatures up to 85oCNot Suitable for Maximum Hot Working Pressure

To maintain the surface finish, simply wipe occasionally with a mild detergent on a soft damp cloth. Dry, using a soft cloth. Never use abrasive cleaners or chemical household cleaners and avoid contact with concentrated bleach.

No regular maintenance is required for this product.
In case of complete replacement Pegler recommend service valves should be fitted to the supply inlets.

For any further help or replacement parts please contact the Service Support Team on 0800 1560050.

It is important to ensure that the water supplies to your taps and mixers are connected in accordance with the water regulations (WRAS) requirements and good plumbing practice.

It is Pegler’s recommendation and good plumbing practice that the supplies of hot and cold water to the bath mixer should be at equal (balanced) pressures in order to provide a consistent flow. Supplies should be from a common source, either mains or tank fed. If supplies are not equal pressures then non return valves (801 check valves), (not supplied) should be fitted in each inlet supply line.

The outlet of the fitting must be at least 25mm above the spill over level of the bath.

It is recommended that in all new and refurbishment installations a thermostatic mixing valve should be installed on the hot inlet supply. The thermostatic mixing valve is designed to prevent scolding when using the hot water supply.

BodyCast Brass
BacknutForged Brass
Anti-rotational washerPolyethelene
HeadBrass Bar
SpindleBrass Bar
Headwork DiscsCeramic
Seat WasherRubber
HandleMetal alloy
Snap fit adaptorsPlastic
ScrewBrass Bar